Without a performing thermostat, your stove won`t become able to heating evenly. Depending on the damage, typically the appliance`s fan might not turn on or away from. If you need to replace the part yourself, order a new replacement part #WBK20K10004 for GE design ovens and adhere to this procedure:

Unplug the oven.

Each appliance repair ought to start with you unplugging the appliance. Because repair involves straight manipulating electrical elements, you need to make sure the particular power is entirely disconnected before obtaining started.

Take away the thermal knob and the rear upper access -panel.

Locate the temperature control system knob within the top access panel. Pull the knob addressing free from the shaft. Then move the oven away from the wall. Unscrew the main rear access screen and set it aside.

Uninstall typically the thermostat assembly.

Track down the boxy exterior with the thermostat set up. It usually provides an X form on the backside. Next, uninstall typically the mounting screws for the front access section that were obscured beneath the thermostat control. Then remove the particular wires attached to the particular part. Because presently there are a lot of different wire connections, take an image of the orientations before you remove any. This will give a person an easy guideline when you set up the modern part.

Typically the thermostat includes some sort of temperature sensing bulb that runs along the back of the applying and into the oven by itself. Release it from the retaining videos at the back of the oven interior and bond it up to the back of the appliance. Set the entire thermostat aside.

Set up the new element.

Unlike most set up procedures, don` capital t reassemble the stove in backward order. First, secure the box of the thermostat assembly directly to the backside associated with the oven simply by tightening the front facing screws under the knob. Once typically the part is firmly in place, affix the wires. Use your picture as an explained ensure everything is usually connected correctly.

Subsequent, thread the sensing bulb down by way of the back side of the oven and straight into the interior. Clip it to typically the rear wall below the element.

Reassemble gas oven repair .

Slip the rear -panel into position and make sure the bottom clips are in place. After that affect the screws along the panel` t edge. Move to the particular front of the appliance and drive the knob again into position.